High Early Strength Non Shrink Cementitious Grout
Features a high compressive strength designed to suit in projects that specifically requires an early strength development. ESPOCEM HES consists of special blend of cement, silica sand, selected aggregate and chemical additives that when mixed with water produces a self-leveling, nonshrinking and very fluid mortar, with high initial and final mechanical strength. The mix is flowable which makes it easier to apply in irregular spaces.
Packaging:
ESPOCEM HES is supplied in 25kg bags.
Yield:
11.7 liters per 25kg bag.
Storage:
Keep the product in dry and sheltered place into original well closed packaging. In these conditions, product shelf life will be 12 months from date of production.
|
Surface Preparation
The surface must be solid, compact, clean, free from dust, cement laitance, curing compound, oils, grease, etc. All loose parts of concrete should be removed. A coarse surface profile with the aggregate exposed is preferred.
Saturate the support with water several hours prior to grouting. Concrete surface should be only damped (with no free water) prior to grouting in order to avoid possible water absorption at the moment of casting. Base plate must be clean and free from oil, grease, rust, etc.
Formwork should be constructed to be leak proof as ESPOCEM HES is a free flowing grout. It should also include outlets for the pre-soaking water.
Mixing
To prepare the mortar, pour into a cement mixer or into a container about 3.0-3.5 Liters of clean water (according to required consistency) for every 25kg bag of ESPOCEM HES.
Mix for 5 minutes using mixer or drill machine fitted with suitable paddle till obtaining a homogeneous mixture, free from lumps.
Application
The mixed grout should be poured only from one side of the formwork to eliminate the entrapment of air. This can be achieved by pouring the grout across the shortest distance. Maintain a constant hydrostatic hand, preferably of at least 15 cm on the side where the grout has been poured, allow 10 cm clearance between the side of the form and the base plate of the machine.
Do not add extra water to the mix more than what specified. If the mix starts to harden, do not use the mix. Prepare a new one.
ESPOCEM HES can be placed in thicknesses up to 25 cm.
Curing
The repaired area shall be cured in accordance with good concrete curing practice and protected from drying winds. Curing shall be done with non-degradable curing compound BETOCURE AR.
Alternately; a wet Hessian cloth covered with polyethylene sheet can also be employed.
Cleaning
ESPOCEM HES should be removed from tools and equipment and mixers with clean water immediately after use. Cured material should be removed mechanically.
Recommendations
ESPOCEM HES is a cement-based product.
During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.
In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.
If ingested, obtain medical attention immediately. Do not induce vomiting.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
EXPANSIVE POWDER FOR CEMENT MORTAR & CONCRETE REPAIR
NON SHRINKAGE GROUT FOR FILLING CABLE DUCTS
NON SHRINKAGE GROUT FOR FILLING CABLE DUCTS
NON SHRINK CEMENTITIOUS GROUT FOR ANCHORING & FILLING
GENERAL PURPOSE NON-SHRINK CEMENTITIOUS GROUT
High Performance Epoxy Grout for Tiles
Acrylic based concrete curing compound