FLEXIBLE HIGH PERFORMANCE FLUID URETHANE EPOXY GROUT
EPOGROUT GP FLEX is a high strength, flexible material three component fluid urethane epoxy grout consisting of base (A), hardener (B) and graded filler (C). Specially formulated to be used as a pile head treatment. When applied to top of the pile head treatment the product provides a highly bonded waterproofing barrier to the pile head which prevents water seepage from ground to the pile caps through the piles.
Packaging:
The product supplied in a three-component 30kg kit
Consumption:
15 liter for 3kg kit
Storage:
Keep the product in dry, covered conditions at 25°C. In these conditions, product stability is 6 months from date of manufacturing.
|
|||||||||||||||||||||||||
Surface Preparation
Concrete must be cured for a minimum of 21 days. All surfaces must be clean, sound, uncontaminated, free from oil, grease, water, paints and dust. Unsound concrete must be removed. Compressive strength of the concrete should not be less than 25 N/mm2
Concrete surface must be totally dry when the mixed product is poured as wet surface might cause de-bonding between concrete and the grout.
Steel surfaces should be free of rust. Sand blasting or grinding is recommended.
Formwork must be well braced, leak proof, strong and well fixed as EPOGROUT GP FLEX product is free flowing grout.
Anchor bolt holes should be clean of all dust, dirt and should be dry.
Mixing
EPOGROUT GP FLEX is supplied in a pre-measured packing. Partial mixing should not be allowed under any condition.
Start mixing by pouring hardener B into base A, the two components must be well mixed to ensure proper chemical reaction. Use a slow speed drill fitted with suitable paddle to mix the product at low number of turns (200 – 300 rpm).
Mix for few minutes till a homogeneous mixture is obtained, then add component C (filler/aggregate) and mix for 2 – 3 minutes until you get homogenous mixture.
Application
Start pouring the grout from one side to eliminate air entrapment, the placement of the grout must be continuous. EPOGROUT GP FLEX should be used immediately after mixing the components and during the working time of the mix.
Cleaning
All used tools should be cleaned with SOLVENTE 10 before the product cures. Hardened material should be removed mechanically.
Recommendations
Wear protective gloves and goggles during application. This product contains chemicals which may be potentially harmful to your health if not used properly. It is strongly recommended to read the material safety data sheets for proper storage and to observe precautions. If contact with skin or eyes happen, use resin cream to remove it from skin followed by clean water, do not use solvent. In case of contact with eyes, use clean water and seek medical consulation.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
General Purpose Flowable Epoxy Grout
High Strength Epoxy Mortar for Pile Treatment
Flowable Epoxy Grout for Pile Treatment
Wax Based Concrete Curing Compound