1.5 mm thick reinforced PVC Membrane for exposed roofing system
Insuwrap 1500 WMR-UV is a homogeneous PVC (polyvinylchloride) sheet waterproofing membrane Ultraviolet Resistant and reinforced with polyester mesh.
Appearance: Reinforced PVC rolled sheet membrane
Membrane thickness: 1.50mm
Colour: Grey
Tested according to testing requirements of ASTM D4434 and DIN 16735.
Roll size: 2.10 m (roll width) x 20m (roll length)
Rolls shall be stored in their original package, in horizontal position and under cool and dry conditions protected from direct sunlight and rain.
Insuwrap PVC membrane does not expire and has a very long life expectancy.
Ambient Air Temperature: +5°C - +60°C
|
Substrate Preparation
The surface of the sloping concrete shall be sound, clean, dry or wet, and uncontaminated. This preparation shall be as such as to leave a sound exposed concrete surface free from dust, laitance and any delirious matter.
Application
LOOSELY LAID PVC SHEET INSTALLATION
Install loosely laid PVC sheets over entire roof area so the light colour is at the visible side towards the substrate.
A. Horizontal Installation:
B. Upstands:
Apply the 1500 WM-UV membrane directly on the concrete up-stand with Neofil S10 contact adhesive
Secure top termination of waterproofing with continuous, Aluminum flashing strip, and Elastoseal PU25, a Polyurethane sealant from Colmef.
C. Seam Installation: Hot air welding and end laps of overlapping sheets according to manufacturer's method statement to ensure a watertight seam installation. Inspect outside edge of seams with pointed metal probe and ensure completed laps lay flat through one of the following methods:
D. Any hole, resulting from construction activities, noted in installed membrane shall be repaired in accordance with manufacturer’s method statement.
CORNER JOINT INSTALLATION
A. Install corner details in accordance to waterproofing manufacturer's written instructions.
Local safety regulations must be observed. Information and advice on the safe handling, storage and disposal of chemical products, users shall refer to the most recent Material Safety Data Sheet.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updated on regular basis. It is the user’s responsibility to obtain the latest version.
1.0 mm thick with Fleeceback PVC Membrane for covered roofing system
1.2 mm thick with Fleeceback PVC Membrane for covered roofing system
1.2 mm thick reinforced PVC Membrane for covered roofing system
1.2 mm thick PVC Membrane for exposed roofing system
1.2 mm thick PVC Membrane for covered roofing system
1.0 mm thick with Fleeceback PVC Membrane for covered roofing system