Solvent Based Silane-Siloxane Penetrating Water Repellant Treatment
IDROSIL XS is a single component penetrating Silane Siloxane treatment which penetrates into porous substrates and then reacts with moisture or pore water from the substrate to form a hydrophobic polysiloxane lining to the capillaries without clogging the pores or capillaries.
Packaging:
IDROSIL XS is packed in 20 & 200 Liter Drums.
Coverage:
6-8m2/liter.
Storage:
Store under cover, out of direct sunlight and protect from extreme temperature. If properly stored, the product has a shelf life of 12 months from the date of manufacturing.
|
Surface Preparation
All surfaces should be clean, sound and uncontaminated.
This preparation should leave an exposed concrete, free from dust, loose particles, deleterious matter, oil, grease, chemical films and other contaminants.
This is best achieved by lightly sandblasting the surface where moss, algae or similar growths have occurred. Treatment with a recommended biocide should be done after sandblasting process.
Pre-Application
Test a small area of the surface (generally 1.0m x 1.0m section) before starting application of the sealer to ensure desired performance results, aesthetics & coverage rate. Allow 5-7 days for the product to fully react.
Application
IDROSIL XS is a single component, applied at full strength and never diluted. Can be used directly from the container, no mixing is required but stir first before use. Apply by brush, roller or low-pressure spray.
On vertical surfaces, IDROSIL XS should be flooded starting at the bottom working steadily upward. For aggressive contamination, it is preferable to slightly sand blast the surface. Algae growth, if exists, should be treated with recommended biocide.
When used as a protective impregnation, a minimum of two applications is recommended. Thus, apply the second coat is still wet.
Cleaning
Equipment and tools used should be cleaned with SOLVENTE 10 immediately after use.
Recommendations
IDROSIL XS should not be swallowed or come in contact with skin and eyes. Inhalation of spray should be avoided. Wear protective clothing, goggles/masks and gloves during application.
Should accidental contact with skin take place, wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty and immediately seek medical advice.
If ingested, obtained medical attention immediately. Do not induce vomiting.
Warning
IDROSIL XS contains flammable solvents. All the precautions must be foreseen for use of such kind of products. For further information or particular use, contact our Technical Department.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Water Repellant Penetrating Water Based Sealer
Water Repellant Acrylic Sealer
Low Viscosity Epoxy Injection Resin