SBR Bonding Agent for Cement Mortar & Concrete
SBR LATEX RIPRESA PLUS is a a carboxylated styrene butadiene copolymer latex admixture with high bonding characteristics. It is stable under wet alkaline conditions forming a reinforcing polymer matrix within cementitious mixes including concrete, screed and mortar. It is mixed with cement mixture to give improved adhesion power to all surfaces, good bonding strength, plasticity, higher impermeability and flexure resistance, higher abrasion and acid resistance and can be considered as a waterproof admixture when mixed with cement.
Packaging:
SBR LATEX RIPRESA PLUS is available in plastic container of 20 liter and 200 liters.
Storage:
Keep sheltered from frost or direct sun and in original tightly closed containers.
Shelf Life:
12 months
|
Surface Preparation:
The surface must be clean, sound, solid, uncontaminated and compact. Contaminated material, dust, corrosion, grease substances and old paints must be completely removed.
The decayed or damaged area to be repaired should be marked. Cut the marked area to a depth of at least 10mm using a hand held concrete saw or disc grinder to avoid feather edging and to provide a square edge. Break out or chip the complete repair area down to sound base using sharp tools or chipping hammer.
Surfaces should be saturated with water to avoid possible backwater at the moment of casting. Before applying the screed for repairing, apply always the anchorage mortar to assure a perfect adhesion to the old cement support. Do not let the anchorage mortar dry but cast fresh on fresh.
For steel reinforcing use BETOFER or EPOZINC to coat steel bars to protect from rust and allow to dry before applying the repairing mortar.
Mixing:
SBR LATEX RIPRESA PLUS must be poured into a cement mixer and then cement and filler can be added. Mix for few minutes till homogeneous mixture free from lumps is achieved.
Cure the surface immediately after applying the mortar by using BETOCURE, a curing compound or spraying water.
Recommendations
Dosage Table
Use | Mixture Ratio SBR Latex Ripresa: Water |
Mixture Ratio Cement: Inert |
||||
Primer in casting resumption |
1 | 2 | 3 | - | ||
Anchorage mortar | 1 | 1 | 2 | - | ||
Plastering up to 10 mm | 1 | 2 | 1 | 3 | ||
Screeds from 10 to 50 mm | 1 | 3 | 1 | 3 | ||
Tiles fixing | 1 | 2 | 1 | 2 | ||
Patching and repair mortars | 1 | 2 | 1 | 3 |
Handle the product with caution. Use gloves and goggles and avoid contact with eyes and skin. In case of contact with eyes, wash abundantly with warm water and consult a doctor immediately.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updated on regular basis. It is the user’s responsibility to obtain the latest version.
Acrylic Bonding Agent & Cement Modifier
Epoxy Bonding Agent
PVA Bonding Agent for Cement Mortar & Concrete
SBR Bonding Agent for Cement Mortar & Concrete
SBR Bonding Agent for Cement Mortar & Concrete (General Purpose)
Light Weight Screed