Single Component Polymer Modified Fairing Coat (3mm or less)
A cementitious polymer modified mortar composed of high resistance cements, silica sand and special additives. It is designed to give thin layers to produce a fair faced appearance, to concrete or masonry surfaces. When mixing with water the product becomes easily workable mortar applicable horizontally, vertically and overhead. Applicable for coatings that are 3mm thick or less.
Packaging:
BETOFINISH F is packed in 25 kg bags.
Yield:
17 liters / 25 kg bag.
Storage:
The product must be stored in dry and sheltered place and into the original well closed bag. In these conditions the product will have a shelf life of 12 months.
|
Surface Preparation
The support must be perfectly cleaned, free from dust, inconsistent parts, traces of form stripping oils, efflorescence, rust etc. Saturate the surface with water to eliminate possible water absorption at the moment of application.
Mixing
To prepare the mortar, pour 7.50 liters of water into a clean container and add slowly the content of BETOFINISH F (25kg). Mix using spiral paddle in slow speed heavy duty drill for few minutes till a homogeneous lump free consistency mix is achieved. Always add powder to water and not the other way around.
Application
Apply BETOFINISH F manually with spatula or steel trowel with a maximum thickness of 3 mm per coat. The product can be applied in more than one layer. Leave the surface rough if the application of following layers is needed.
Only the last coat can be smoothed with sponge trowel few minutes after the application. If surface dries too fast during the smoothing, it can be dampened by water spraying to facilitate the trowel application. Care should be taken not to overwork the surface.
When high mechanical resistant thin plaster is required, BETOFINISH F must then be reinforced with a special fiber tissue.
Curing
Curing is not generally needed however under extreme conditions - high temperature and drying winds, BETOCURE AR shall be used as a curing compound.
Cleaning
BETOFINISH F should be removed from tools and equipment and mixers with clean water immediately after use. Cured material should be removed mechanically.
Recommendations
BETOFINISH F can be harmful to skin as it contains cement powders which may releases alkalis when mixed with water. During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.
In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly. If ingested, obtain medical attention immediately. Do not induce vomiting.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Two Component Polymer Modified Cementitious Mortar
Fibre Reinforced Shrinkage Controlled Mortar for Concrete Repair
Fluid Non-Shrinking Mortar for Degraded Concrete Repair
High Compressive Strength Repairing Mortar
High Resistant Mortar for Degraded Concrete Structural Repair
HIGH STRENGTH PILE CAP CEMENTITIOUS LEVELING GROUT
Acrylic based concrete curing compound