Fast Cure Solvent-Free Epoxy Self Leveling Topping (2.0-4.0mm) for Concrete Floors
EPOFLOOR SL (FCT) is a solvent free self-leveling floor topping based on formulated epoxy resin, curing agents and silica sand specially selected for their ability to be applied and cured in cold temperatures.
Packaging:
EPOFLOOR SL (FCT) is supplied as a pre-measured kit depending on the customer’s requirements. Our standard packing is 15 liter kit.
Storage:
Keep in tightly closed containers and in sheltered and dry place with a temperature between +5°C and +35°C.
In these conditions it maintains its characteristics unchanged for 12 months.
|
Substrate preparation
The concrete must be at least 28 days old. The concrete must be free from loose matter, oil and dirt before starting surface preparation.
The best method to prepare the surface is dry grinding using a specialized planetary grinder.
Before grinding, the surface must be free from any degreasing or cleaning chemicals which may have been used. At the end of grinding, the surface should be flat.
Surface irregularities and blow holes shall be repaired with EPOFINISH FC.
When the filler is hardened, grinding and leveling of the patched area is recommended to ensure a good finish.
Ensure dust is removed from the surface using an industrial vacuum.
For best finish and adhesion, treat the surface with PRIMER POXY FC. In case the surface is very absorbent, apply a second coat of primer within the allowed recoating time.
Application Thickness
A thickness of 2.0 – 4.0 mm per coat over a primer is recommended.
Items Needed
Method
Adjust the rake to the desired thickness.
Using a drill and a paddle at low speed, stir the resin (Component A) for 1 min. Slowly add the hardener (Component B) and increase mixing speed. Mix for 1-2 minutes, ensuring proper mixing between both components A & B.
Slowly add the Sand (Component C) and increase mixing speed. Mix for 1-2 minutes till a homogeneous streak free product is obtained.
Pour the mix onto the floor immediately and spread using the rake. After about 5 minutes use the spike roll to remove all entrapped air.
Cleaning
Clean equipment with SOLVENTE 10. In case of spillage, use fine silica or cement to absorb the spill and dispose of according to local regulations.
Components
Study the MSDS of the product before use or storage.
EPOFLOOR SL (FCT) is not regulated per the “Directive 67/548/EEC EU Dangerous Materials List” so no special labeling is needed.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Fast Cure Solvent-Free Epoxy Repair Mortar for Concrete Floors
Fast Cure Solvent-Free Epoxy Topcoat for Concrete Floors
Fast Cure Solvent-Free Epoxy Self Leveling Topping (0.8 – 2.0mm) for Concrete Floors
2.0mm thick PVC Membrane for Underground Structures & Tanking System
Fast Cure Solvent-Free Epoxy Repair Mortar for Concrete...
Solvent Free High Performance Epoxy Primer
Thinner / Cleaning Solvent