Grouting & Anchoring

Cement Based Grouts

Monneli Espansil Cable Flow

NON SHRINKAGE GROUT FOR FILLING CABLE DUCTS

Uses
ESPANSIL CABLE FLOW is specially designed for uses where high fluidity, extended working time, no bleeding, segregation or plastic settlement shrinkage, high strength and resistance to chloride penetration are required
Grouting of post tensioning cables or bar where complete encapsulation of the reinforcing and protection from corrosion are required
Pumping grout through small opening over long distances
Grouting cable anchorages for highly stressed reinforcing steel
back to Grouting & Anchoring
Technical Information
Product Description

A high performance, expanding, shrinkage compensated anchoring grout. It is formulated to produce a fluid, non-blending, non-shrink grout with extended working time. It contains migratory corrosion inhibitors to provide corrosion protection for highly stressed steel cables, anchorage and rods. Its fluid characteristics allows the product to be pumped through small openings over long distances and placed into relatively inaccessible areas.

Advantages
  • Ready to use, requires only the addition of specified amount of water
  • Easy to pump or pour
  • Controlled expansion
  • Non-shrink performance provides excellent bearing
  • Flowable and self-leveling
  • High strength
  • Excellent cohesive properties
  • Resistant to water washout and dilution by water in wet ground conditions
  • Thixotropic properties reduce material loss in fractured ground
  • Reduced bleeding
  • Improved resistance to Sulphate attack
  • Very low permeability
Compiliance Standard

n BS 8110, Part 1, Sec. 8, BS 4551

n EN 445, 446 & 447

n UNI 8147

Packaging, Coverage / Consumption

Packaging:

ESPANSIL CABLE FLOW is supplied in 20kg paper bags.

 

Consumption: 

20kg bag. ESPANSIL CABLE FLOW yields approximately 13.5 Liters of grout when mixed with specified amount of water.

Shelf Life & Storage

Storage:

Keep in a sheltered and dry place in closed packaging. In these conditions, the product maintains its stability for at least 12 months.

Colors
Grey
Technical Properties
PROPERTIES RESULTS
Appearance Grey granular powder
Wet density at 25⁰C  2.0 kg/L 
VOC 7.0 g/L 
Compressive strength (ASTM C579) 
At 7 days 42 N/mm²
At 28 days >50 N/mm²
Flexural strength (ASTM C580) 
At 7 days 6.5 N / mm²
At 28 days 7.0 N / mm²
Chloride content Nil
Fluidity 
Initial 10-20 seconds
After 30 minutes 20 seconds
Volume change Positive expansion up to 4%
All values are subject to 5-10 % tolerance
Application Information
Instructions for use

Surface Preparation

The area / duct to be grouted should be cleaned with water before the application of grout. Any free water must be drained out. Cable anchorages should be sealed before the duct grouting is carried out.

Mixing

Add one 20kg bag of ESPANSIL CABLE FLOW into 6.5 to 7 Liters of potable water. For mixing small quantity use a slow speed drill fitted with a suitable paddle at 200-300rpm. For mixing large quantity, it is recommended to use proper grout vane mixer. Adding more water than the specified limits will result in loss of properties. Mix for 5 minutes till obtaining a homogeneous product, free from lumps.

Application

Place ESPANSIL CABLE FLOW by pouring or pumping into the area to be grouted in a continuous manner and do not allow air pockets to develop. The placing should be within maximum 20 minutes of mixing to gain benefit of the expansion process.

Ensure proper evacuation of air, filling process has to be started from one side till the grout flows at the other side.

ESPANSIL CABLE FLOW can be placed in annular gaps of up to 60 mm in thickness.

Cleaning

All used tools should be cleaned with water before the product cures. Cured materials should be mechanically removed.

Recommendations

n For application during summer season, the following precautions should be considered:

n Use cold water (20-23⁰C) for mixing the grout

n Try to eliminate application during the peak temperature of the day. Mix enough grout that can be produced during the workable time

n Store unused materials in a covered dry place

n It is recommended to shade the working area during mixing and pumping the grout

Additional Information
Health & Safety

ESPANSIL CABLE FLOW can be harmful to skin as it contains cement powders which may releases alkalis when mixed with water.

During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.

 

In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.

If ingested, obtain medical attention immediately. Do not induce vomiting.

Important note

The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.

additional materials
Fast Download
Technical Properties Sheet
download (*.pdf 0.25Mb)
OTHER PRODUCTS
More Products from this section
Monneli Espansil

EXPANSIVE POWDER FOR CEMENT MORTAR & CONCRETE REPAIR

Monneli Espansil Cable Flow*
NON SHRINKAGE GROUT FOR FILLING CABLE DUCTS

">

NON SHRINKAGE GROUT FOR FILLING CABLE DUCTS

Monneli Espocem

NON SHRINK CEMENTITIOUS GROUT FOR ANCHORING & FILLING

Monneli Espocem GP

GENERAL PURPOSE NON-SHRINK CEMENTITIOUS GROUT

Monneli Espocem GPP

GENERAL PURPOSE NON-SHRINK CEMENTITIOUS PRECAST GROUT

view more
RANDOM PRODUCT
Monneli Elastothane TR

Pitch Elastomeric Single Component Polyurethane Waterproofing Membrane

Uses
ELASTOTHANE TR can be used for a wide range of waterproofing applications for:
Roofs
Basements and foundations
Tunnels and bridges
Terraces and balconies
Car decks
Plaza decks
Planter boxes
Retaining walls
Internal wet areas (kitchens, bathrooms)
Fountains and pools
Sewages works
Tanking applications in areas where aggressive ground water conditions prevail
Contact us
Choose a location
P.O. Box: 123808, Dubai
Toll: +971 4 8803488
Fax: +971 4 8803450
Site Map