Ready-mixed, Acrylic Pinhole Filler
ACRYFIL is a ready-mixed putty based on a blend of acrylic polymer and graded fine filler. ACRYFIL had been specially developed for use with MANTOCOLOR.
Packaging:
ACRYFIL is supplied in 25 kg container.
Consumption:
0.2 – 0.4 kg/m² (depending on substrate conditions).
Storage:
Keep the product in a dry and covered place away from direct sunlight into the original well-closed packaging. A shelf life of 12 months is expected if stored as recommended.
|
Surface preparation
The surface must be solid, compacted, sound, uncontaminated, free from dust, curing compound, oil, and grease before applying the product.
ACRYFIL can be applied to existing coating. In order to determine the compatibility with the existing coating, it maybe necessary to carry out adhesive test.
Priming
It is recommended to apply IDROSIL XS, a Silane-Siloxane penetrating primer for dusty or flaking surfaces and in some cases on the existing coating. For further information contact Colmef Technical Department.
Mixing
ACRYFIL should be mixed well before use.
Application
Apply ACRYFIL in a thin layer on the prepared surface. Material should be tightly trowelled on the surface to ensure that all pin holes and irregular areas are completely filled. If a second layer is needed, wait till the first layer is dry. Total recommended thickness of ACRYFIL should not exceed 1mm.
Once the final layer has dried, it may be sanded lightly to achieve a full smoothness. Before applying the overcoating be sure that the coated surface is not contaminated and free from dust or cement debris as this will affect the top coat adhesion with the surface.
Cleaning
Clean the used tools with water immediately after completing the job and before the product dries.
During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.
In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.
If ingested, obtain medical attention immediately. Do not induce vomiting.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Solvent Based Styrene-Acrylate Protective and Decorative Coating
Elastomeric, Protective, Anti-Carbonation & Waterproof Coating
Water Cleanable Epoxy Tile Grout
Solvent Based Silane-Siloxane Penetrating Water Repellant Treatment
Elastomeric, Protective, Anti-Carbonation & Waterproof Coating