High Quality Cementitious Plastering from 3 to 10 mm Thickness
RASANTE G-30 is a cement mortar composed of bonding agents, fibre, lime, additives and synthetic resins which gives the product the characteristics of perfect adhesion to the support, easy workability and weather resistance.
Packaging:
RASANTE G-30 is supplied in 50kg multilayer bags.
Consumption:
1.6kg / m² per 1 mm of thickness.
Storage:
Store in dry covered place in the original closed bags. In these conditions, the product shelf life is 12 months from the date of production.
PROPERTIES | RESULTS |
Colour | Grey or white |
Appearance | Powder |
Density at 25°C | 1.6 kg/L |
VOC | 2 g/L |
Adhesion to concrete surface | >0.5 N/mm2 |
Compressive strength | >10 N/mm2 |
Compatibility with adhesive | Excellent |
Time of initial setting at 25°C | 1.50 - 2.00 hours |
Time of final setting at 25°C | 3.5 - 4.00 hours |
Final setting after | 28 days |
Thickness per coat | from 3 to 10 mm |
Humidity resistance | Excellent |
All values are subject to 5-10% tolerance |
|
Surface preparation
The substrate should be free of loose particles, dust, dirt, grease, oil or paint. Absorbent and porous substrates should be moistened with water prior the application of RASANTE G-30.
Concrete or block substrates should have been allowed to cure sufficiently. All shrinkage movements should taken place before applying RASANTE G-30.
Saturate the surface with water and wait for the evaporation of excess water before applying the mix.
Mixing
Pour 8-9 Liters of clean water into a cement mixer drum. Add 50 Kg bag of RASANTE G-30 into the drum and mix till a homogeneous mixture free from lumps is obtained. A low speed drill fitted with a suitable paddle can also be used for mixing the product. Keep the product for 5 minutes and remix before application.
Application
Apply the mixture on the substrate with a metallic smooth spatula. Do not apply more than 10 mm coat thickness.
For the application of 3-4 mm thick plaster, it is recommended to prime the wall with a mix of SBR LATEX RIPRESA, a SBR bonding agent, and water at a ratio of (1:1). Apply the mix on the surface while the primer is still tacky.
Applied plaster of RASANTE G-30 should be cured for minimum 2 days.
Cleaning
Tools and equipment should be cleaned with water immediately after use. Hardened materials should be mechanically removed.
Recommendations
RASANTE G-30 is a cement-based product; avoid contact with skin or eyes.
During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.
In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.
If ingested, obtain medical attention immediately. Do not induce vomiting.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
BENTONITE
Spatter Dash Bond Coating
High Quality Spatter Dash Bond Coating
Superior Quality Spatter Dash Bond Coating
Superior Quality Spatter Dash Bond Coating
Water Repellant Anti-Fungus Tile Grout