Non-Woven Geotextile Reinforcing / Protection Fabrics
ARMOFAB is a wide range of geotextile fabric that can be used as reinforcement for wide variety of applications or protection for waterproofing membranes.
ARMOFAB is produced in nine grades (ARMOFAB 120P ARMOFAB 140P, ARMOFAB 200P, ARMOFAB 300P ARMOFAB 350P, ARMOFAB 400P, ARMOFAB 500P, ARMOFAB 800P & ARMOFAB 1000P). Each grade has a unique property that when applied or used with other suitable COLMEF products, gives the required results and protection for the waterproofing membrane against back filing or concrete works.
For waterproofing protection of substructures, roofing, watertanks bridges, roads & infrastructure works. Immediately lay ARMOFAB along the surface. Make sure to apply the fabric completely by gently rolling.When joining the
ARMOFAB geotextile together, be sure to keep an overlap of at least 5 to 10 cm. ARMOFAB is available in different grades. Refer to the technical properties tables provided below.
When ARMOFAB is to be used in conjunction with other COLMEF products, make sure to follow the recommended method of application for each product by referring always to the Technical Data Sheet.
All surfaces where the ARMOFAB is to be applied must be well compacted, smooth, and free from projections. When otherwise necessary, it is highly advised to use compressed air or a wire brush in order to remove further dirt, or other inconsistencies in case it is applied on concrete surfaces.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updated on regular basis. It is the user’s responsibility to obtain the latest version.
Spray Polyurethane Foam For Roof Waterproofing
Spray Polyurethane Foam
Elastomeric Acrylic Waterproofing Membrane