Self Leveling Rapidly Setting Mortar
ULTRALIVEL is a rapidly setting self-leveling floor underlayment. It is a fine powder composed of special cement, selected aggregates, organic resins and other additives, requiring only the addition of water to form a very flowable mixture, perfectly leveling, with easy application, good adhesion to the support and rapidly setting.
Packaging:
ULTRALIVEL is pack in 25 kg bags.
Consumption:
2.1 kg/m² per millimeter of thickness.
Storage:
Keep the product in covered and dry place. Shelf life is 6 months from date of production if stored properly.
|
Surface preparation
The surface of the concrete to be prepared shall be sound, clean and uncontaminated.
This preparation shall be such as to leave a sound exposed concrete surface free from dust, loose particles and any deleterious matter. If the concrete surface is defective or has laitance, it must be cut back to a sound base. Excess laitance deposits are best removed by light mechanical scrabbling, grinding or grit/captive blasting followed by vacuum cleaning to remove dust debris. All cracks and imperfections shall be repaired using BETOFINISH C, a cementitious fairing coat.
New concrete floors should be allowed to cure for at least 28 days before applying the primer.
Priming
The substrate must be primed with PRIMER A18, a synthetic resin high penetrating primer.
PRIMER A18 should be applied by brush or roller on to the cleaned surface area (particularly hidden surfaces) at a rate of 5-6 m² /Liter.
The primer should be left to achieve a tack-free condition before applying the top coat. A second coat of primer may be required if the substrate is excessively porous.
Mixing
Pour into a container with 5.0 Liters of water for 25 Kg bag of ULTRALIVEL.
Add the product to the water and mix with a low speed electric drill fitted with a suitable paddle for 2 mins scraping sides and bottom of the can, until a uniform, lump free consistency mix is achieved. Allow the mix to stand for 3 mins and then remix again for 30 secs.
Mix a quantity of product that can be applied within 30 minutes only. Do add water to the mixture after it had began to set.
Application
Pour the mixed product into the surface and spread to the desired thickness using flooring rake and a spike roller.
Protect the floor after leveling the mix from direct sunlight, high winds or rain.
ULTRALIVEL can be applied for thickness from 3 up to 10 mm per coat. For more thickness add around 30% of sand (Quartzo no.1)
It is possible to apply flooring material on top of ULTRALIVEL screed (such as ceramic, carpet, etc.) after nearly 48 hours from curing the product (depending on the thickness, the supports humidity and weather conditions).
Curing
Curing of the completed floor shall be carried out using a combination of damp hessian and polythene sheeting for a period of no less than 2 days.
Protect all treated surfaces from wind and frost, by covering with plastic sheeting, damp hessian or
equivalent.
Finishing & Clean-up
The product is self-leveling and requires minimal finishing or troweling operation.
Clean tools and equipment with water before the material hardens.
Recommendations
ULTRALIVEL can be harmful to skin as it contains cement powders which may releases alkalis when mixed with water.
During application, wear appropriate protective clothing, goggles, gloves and respiratory equipment if necessary.
In case of contact with skin, rinse with water and again wash thoroughly with soap and water. In case of contact with eyes, rinse with plenty of water and seek medical advice accordingly.
If ingested, obtain medical attention immediately. Do not induce vomiting.
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version.
Self-Levelling Cementitious Mortar
Self-Leveling Cementitious Mortar
Self-Leveling Cementitious Mortar
Light Weight Screed
Light Weight Screed
Synthetic Latex Additive for Cementitious Grout