Water Based Concrete Curing Compound
A clear liquid based on sodium silicate to cure, harden and seal freshly hardened concrete. It is easy to apply, leaves no residue and dries quickly.
|
Pre-Application
BETOCURE S125 should be stirred before application. Product is ready for use directly from the drum and should not be diluted with water. BETOCURE S125 is not a film forming product but should fully saturate the concrete for maximum effect. Perform enough application to fully saturate the concrete without leaving puddle.
Surface should be free of water. In case of horizontal surfaces, the product should be applied as soon as the bleed water has evaporated from the surface.
Application
BETOCURE S125 should be applied uniformly by sprayer, brush, roller or soft bristled broom to the surface of fresh concrete. For best results, use spray for application.
Application should be at the rate of approx. 15m2/liter. The coating produces a light duty surface. It is the responsibility of the user to adjust to curing rate to properly regulate the hydration of the concrete. Two applications maybe required. BETOCURE S125 should be applied to newly hardened concrete immediately after demolding. It should never be applied on concrete which has started to dry out, otherwise the hydration mechanism will be seriously impaired. Do not allow compaction or vibrating acts close to the sprayed area as this will break the freshly sprayed film.
Overcoating
Over coating can be done without removal of curing compound provided the application is within the specified coverage rate.
Cleaning
Equipment and tools used should be cleaned promptly with water.
Recommendations
BETOCURE S125 does not fall into hazardous classification of current regulation. However, it should not be swallowed or allowed to come into contact with skin or eyes in either spray or bulk form. Splashes on the skin should be removed with water. In case in contact with eyes, rinse immediately with water and seek medical attention.
If swallowed, seek medical attention immediately. Wear suitable protective clothing, gloves and goggles
The information in this Technical Data Sheet is based on Colmef Monneli’s experience. Colmef Monneli does not accept any liability arising from the use of its products as it has no direct or continuous control over where or how its products are applied. All Colmef Monneli’s Data Sheets are updates on regular basis. It is the user’s responsibility to obtain the latest version
Acrylic based concrete curing compound
High Efficiency Resin Based Curing & Sealing Compound
Water based concrete curing compound
Wax Based Concrete Curing Compound
SBR Bonding Agent for Cement Mortar & Concrete